envelope-o linkedin youtube at document map phones question user phone twitter facebook bars angle-left angle-right angle-up angle-down vk

PP-KIT developer kit

Applications

  • Pulse picking
  • Regenerative amplifier control

Composition

  • One PP-CONTROL synchronization board
  • One or two HVSW-03 or HVSW-04 high voltage switches
  • PC software
  • Auxiliary power supplies, interconnective cables etc.

hvsw-03-manual-en.pdf

Download user manual (2.6Mb)

pp-control-manual-en.pdf

Download user manual (1.4Mb)

There is a typical task in the laser industry – resampling down the repetition rate of pulsed lasers. Most commonly this task is related to pico- and femtosecond lasers and is known there as pulse picking.

Typical seed laser has the repetition rate of tens of MHz (from 10MHz up to 100MHz or even more). For further amplification the repetition rate of tens of kHz is needed. As a result some kind of pulse picker is required.

The electro-optical crystal like RTP, DKDP or BBO, simply assembled together with the polarizer, and properly driven with the high voltage electronics can select and transmit some of optical pulses from the pulse train and reject all others.

Picture 1 - Resize.png

In the similar way input/output of pulses into/from the regenerative amplifier may be controlled.

Picture 2 - Resize.png

The leading edge of electrical pulse (of L/4 voltage) should be applied when the optical pulse is passing through the area 1. The falling edge of electrical pulse applied when the optical pulse is in area 1 again will release the optical pulse from the amplifier.

So, the first key element of the aforementioned schemes is the high voltage switch capable to produce pulses with very fast rise and fall times (e.g. HVSW-03).

The second key element requested by pulse picking applications is the control board (e.g. PP-CONTROL) capable to adjust electrical pulses relatively to optical pulses.

In the simplest case the control board solves namely this task, i.e. aligns the sequence of high voltage pulses relatively to the train of optical pulses. In dependence on high voltage switch modification it may be either pulse picker or regenerative amplifier driver.

In the most advanced case the control board takes care of complete pico- or femtosecond laser, including one pulse picker and one regenerative amplifier.

Picture 3 - Resize.png
hvsw-03-manual-en.pdf

Download user manual (2.6Mb)

pp-control-manual-en.pdf

Download user manual (1.4Mb)